Futaba Fp-r127df Manual

1. Futaba R168df Receiver Manual

.No part of this manual may be reproduced in any form without prior permission.The contents of this m anual are subject to change without prior notice.This manual has been carefully written. Please write to Futaba if you feel that any corrections or clarifications should be made.ABLE OF ONTENTS AFETY.Meaning of Special Markings.2 Precautions During Flight.2 Nicd Battery Charging Precautions. 4 Storage and Disposal Precautions.4 Other Precautions.5.6 EFORE Set Contents. 6 Name and Handling of Each Part.7 Transmitter Operation and Movement of Each Servo.10.11 NSTALLATION AND.AFETY To ensure safe use, observe the following precautions. Meaning of Special Markings Pay special attention to the safety at the parts of this manual that are indicated by the following marks.

Mark Meaning Procedures which may lead to a dangerous condition and DANGER cause death or serious injury to the user if not carried out properly.Always test the digital proportional R/C Extend the antenna to its set before use. Any abnormality in the digital proportional R/C set, If the antenna is or model, may cause a crash. Collapsed, the ef- fective range of.Before starting the engine, check that the Test the radiowaves.Ni-cd Battery Charging Precautions (If using a Ni-cd battery) Charge the digital proportional R/C nicd WARNING battery with the special charger, or digi- tal proportional R/C quick charger, sold Always charge the nicd separately. Battery before each flight. Overcharging may cause burns, fire, injury, blindness, etc.Futaba is not responsible for damage, etc. Caused by the use of parts other than Genuine Futaba The plastic may melt and fail to parts. Use the parts described in the instruction function.EFORE Set Contents After opening the carton, first check if the following items are provided.

The set contents depend on the type of set. T4YF Transmitter R136F R148DF R127DF Receiver (not for USA) S3003 S3004 S3101 Servo (x3) (x4) (x2) Receiver Battery Nicd Battery.Name and Handling of Each Part T4YF TRANSMITTER (Front Panel) Trainer Switch Operates the instructor transmitter Antenna when using the trainer function.

The student transmitter can be operated only while this switching is being Carrying Bar pressed. Hook Elevator Throttle (Mode 1) (Mode 1) Throttle.T4YF TRANSMITTER (Rear Panel) Trainer jack Connects the trainer cord when using the trainer function. (The trainer cord is sold separately. ) (See page 15 for the trainer function opera- tion instructions.) Battery cover Use when replacing the battery.

Slide the cover downward while pressing the part marked '.RECEIVER Output / battery connector R127DF '1': Aileron servo (CH1) Crystal '2': Elevator servo (CH2) '3': Throttle servo (CH3) The crystal is replaced from the side of the '4': Rudder servo (CH4) receiver. '5': (Not used) (CH5) '6': (Not used) (CH6) '7': (Not used) (CH7) FP-R127DF '8': (Not used) (CH8).Transmitter Operation and Movement of Each Servo Before making any adjustments, learn the operation of the transmitter and the movement of each servo.

(In the following descriptions, the transmitter is assumed to be in the standby state.) AILERON OPERATION When the aileron stick is moved to the Aileron(ch1) (Viewed from the rear) right, the right aileron is raised and the left.NSTALLATION AND DJUSTMENT This section describes the installation method and adjustment method after installa- tion when installing the receiver, servos, etc. To the plane. Connections Connection example is shown below. Connection Example Receiver R127DF.The number of servos depends on the set.

FP-R127DF Dual Conversion 7CHANNEL.WARNING Connector Connection Servo Throw Insert the receiver, servo, and Operate each servo horn over battery connectors fully and its full stroke and adjust so that firmly. The pushrod does not bind or is not too loose.

If vibration, etc. Causes a connector to work loose during flight, the plane may Unreasonable force applied to the servo crash.Adjustments The operating direction, neutral position, and steering angle of each servo are adjusted. CAUTION The basic linkage and adjustments of the fuselage conform to the fuse- lage design drawings and kit instruction manual. Be sure that the center of gravity is at the prescribed position. Adjustment Procedure Before making any adjustments, set all the SERVO REVERSER switches.SING THER UNCTIONS Using the Frequency Board Stick the band number seal to the frequency board. Install the frequency board to the antenna.

Pass the frequency board over the small part of the antenna and slide it to the large part.Use side A or side B, depending on the thickness of the antenna.Trainer Function The trainer function is a very effective way for training students. To use it, the special trainer cord (sold separately) is necessary.

Your exciting story begins as you head out on safari to rescue wildlife from danger. Welcome them into the zoo of your dreams and give the animals a place to grow up safe and strong with the help of your skilled zoo team in this amazing free game. Wonder zoo mod apk offline.

The special trainer cord can be connected to SKYSPORT4, FF5, SKYSPORT6, 6X series, 7U series, 8U series, 9C series, and PCM1024Z series transmitters. Operating Instructions Instructor side: Turn on the power switch and extend the antenna to its full length.Charging The Nicd Battery The transmitter and receiver nicd batteries can be charged simultaneously or inde- pendently. Charging The Nicd Battery Connect the charger transmitter connector to the transmitter charg- ing jack and the charger receiver connector to the receiver servo nicd battery.EFERENCE Ratings.Specifications and ratings are subject to change without prior notice. TRANSMITTER T4YF RECEIVER R136F (not for USA) (2 sticks, 4 channels, FM transmitter) (6 channels, FM receiver) Transmitting frequency: 29, 35, 36, 40, 41, Receiving frequency: 29, 35, 36, 40, 41, 60, 50, 60, 72, 75 MHz 72 MHz Modulation method: FM (Frequency Modu.If your digital proportional R/C set does not operate, its range is short, it intermit- tently stops operating, or it operates erroneously, take the action shown in the table below. If this does not correct the trouble, please contact a Futaba dealer. Check point.Glossary The following defines the symbols and terms used in this instruction manual. Aileron (AIL.) Rudder (RUD.) Control surface at the left and right sides of the Tail control surface that controls the direction of main wing of an aircraft.

Futaba R168df Receiver Manual

It usually controls turn- the aircraft.FUTABA CORPORATION Makuhari Techno Garden Bldg., B6F 1-3 Nakase, Mihama-ku, Chiba 261-8555, Japan Phone: (043) 296-5119 Facsimile: (043) 296-5124 ©FUTABA CORPORATION 2003, 04.